Pyxis

The Pyxis camera rotator was specially designed with the guiding chip of the SBIG ST-x CCD cameras in mind. Simply locate a suitable guide star, enter the position angle and let the Pyxis rotate the camera so that a bright guide star is centered on the tracking chip. For those with alt-azimuth mounts, the Pyxis can derotate the field while tracking the object. A simple Windows interface program is provided that controls rotation and derotation modes as standard. The control software is free and updates are also free.

Utilizing a precision sealed 50mm bearing, the Pyxis provides the rigidity and stability you have come to expect from Optec instruments. Weighing under 2 lbs the Pyxis can support and rotate the SBIG ST-x line of cameras without slipping. If the holding torque of 27 inch-pounds is exceeded, the drive gear will slip but no damage to the Pyxis will occur. The running torque is 15 inch-pounds. This limit to the holding and running torque will also prevent damage to cables and instruments if a rotational stoppage does occur. The Pyxis can handle the SBIG AO-7 adaptive optic with camera. The clear aperture of the Pyxis is 1.65 inches and adds about 1.6 inches to the back focus. For large instrument packages or systems that use the SBIG STL camera with large CCD, the the new Pyxis 3-inch model is suggested.

Intelligent firmware will choose the best direction for each move to keep camera cables from binding. The built-in circuit board provides all the control needed - no external hand control box is required. Windows control software is provided with the Pyxis and software integrators will appreciate the simple command language allowing them to easily select a new position angle or activate the derotation control for alt-azimuth tracking.

The Pyxis was designed for use with the Optec TCF-S Focuser and IFW Filter Wheel. Fully compatible with the Optec NextGen MAXfield and NextGen WideField telecompressors the Pyxis can be used at 1X, 0.5X, and 0.33X using any SBIG camera. However, the NextGen telecompressors used with the Pyxis are not compatible with the SBIG cameras having an attached CFW-8/9/10 filter wheel. In this case the back focus distance for the NextGEN reducer is exceeded.

Read an Astromart review of the Pyxis written by Bob Benamati noted astro imager. Keep in mind that his Pyxis was one of the first and was equipped with the original low torque motor and not the high torque model used now.

The Ewell Observatory in California has many dream telescopes with the latest high tech gear. Browse their web site to see the Pyxis mounted with various camera configurations and view the results.

IMPORTANT INFORMATION FOR PYXIS OWNERS PREVIOUS TO JULY 2007

Ted Agos has suggested an improved way to minimize wobble in the 2-inch Pyxis. By adding three nylon tipped setscrews to the camera side gear cover and carefully adjusting them, the wobble seen with heavy instrument loads is greatly reduced. Optec will modify any Pyxis returned to us for modification at no cost. Return shipping by UPS ground in the U.S.A is also free. Shipping for customers outside the U.S.A. is at cost.

NEW FIRMWARE AND CIRCUIT BOARD AVAILABLE

New firmware is available for the Pyxis 2-inch and 3-inch models. It was suggested that the unit have the ability to adjust the HOME or 0 position angle by software means instead of physically rotating the unit. Seeing the wisdom of this, the firmware has been modified to allow the user to set 0 PA within +/- 15 degrees of the default position. Cost is $25.00. New control software version 1.30 must be downloaded to make use of this new command. This firmware is only compatible with Rev. 1 circuit boards for the Pyxis 2-inch. Earlier models require a circuit board replacement. Special pricing is available for these users who desire the upgrade. Call Optec.